Plumbing referrals for Winston-Salem & nearby townsCall: (336) 677-0730
(336) 677-0730

Well Pump Repair in Spencer, NC

plumberswinstonsalem.com

Independent plumbers who sort out pressure loss in Spencer's older homes and handle the rare well pump nearby.

Weak water in Spencer?
Call now to be connected with a local plumber in Spencer.
(336) 677-0730

Spencer is inside Salisbury-Rowan Utilities' water service area, and few homes in town have a private well, so a well pump is seldom the reason the taps go weak. In Spencer's older houses, the cause is more often a leak or old piping on the owner's side of the meter. Call the number on this page to be connected with a local plumber in Spencer.

Plumber replacing a well pressure switch, well pump repair in Spencer, NC

Spencer's water and its old houses

Spencer grew up around Southern Railway's Spencer Shops, now the NC Transportation Museum, and its housing is among the oldest around: median year built 1950, with about 76 percent of homes built before 1980 and about a third before 1940. SRU supplies the town with treated Yadkin River water, maintains the line up to the meter and leaves the owner responsible from the meter to the house. SRU's service line inventory found no lead or galvanized service lines needing replacement, but that covers service lines, not the pipes inside an old house.

What to do now

  1. Check whether you have a pump at all. An SRU bill and a meter mean you don't. A pressure tank and well cap mean you do.
  2. Compare hot and cold. If only hot water is weak, look at the water heater, not the supply.
  3. Try several faucets. One slow tap often means a clogged aerator or a worn valve.
  4. Read the meter with everything off. If it keeps moving, water is leaking somewhere between the meter and the fixtures.
  5. Find the main shutoff so you can close it quickly if a leak turns up.
  6. On a well, check the pump breaker and reset it once only.
Call now to be connected with a local plumber in Spencer.
(336) 677-0730

Symptoms and likely causes

SymptomLikely cause
Pressure low at every fixture on SRU waterLeak on the owner's line, failing pressure-reducing valve or corroded interior pipe
One fixture weakClogged aerator or a worn valve cartridge
Meter turning with taps closedHidden leak inside or under the house
Rapid clicking on a well systemPressure tank lost its air charge
No water at all on a wellTripped breaker, failed switch or a dead pump

What affects cost

  • Whether the fault is a valve, a leak or a section of old pipe
  • How hard the pipe is to reach under an older house
  • For a well home, whether the pump has to be pulled
  • Whether a permit is needed; Rowan County Building Inspections handles Spencer

A plumber can usually tell within one visit whether the trouble is a fixture, a valve, a leak or the piping itself, and whether a bigger repair is worth planning.

Well Pump Repair questions in Spencer

I'm on public water and my pressure fell off. Can a pump be the reason?
No pump is involved on SRU water. In Spencer, low pressure is more often a leak or old pipe on the owner's side of the meter, or a pressure-reducing valve that has worn out.
How do I know whether my house uses a well or a public water system?
An SRU water bill and a meter mean public water. A pressure tank and switch in the house plus a well cap outside mean a private well.
What does the pressure tank do, and what happens when it fails?
On a well, the tank holds water under air pressure so the pump doesn't start for every small draw. When the air charge is gone, the pump short cycles and wears out early.
The water stopped at every tap in the house. Where do I start?
If you're on SRU water, check with neighbors and the utility for an outage or main break first. On a well, check the pump breaker and the tank gauge, then call a plumber if the gauge reads near zero.

More plumbing services in Spencer

Well Pump Repair nearby

Call now to be connected with a local plumber in Spencer.
(336) 677-0730

Last updated:

☎ Call (336) 677-0730